My Beam mini (2) shows an E1 message. What can I do?

The E1 fault has to do with the water sensor. It now measures an empty tank when that is not the case. Fortunately, you can reset this sensor briefly so that this message is no longer displayed incorrectly.
Follow the steps below to solve your problem.

- Switch off Beam mini (2) and disconnect the plug from the wall socket;
- Beam mini (2) consists of a bottom (the water reservoir) and a top (the water tank);
- Remove the top of Beam mini (2) and place it temporarily to one side, preferably in a sink;
- Remove the water from the bottom of Beam mini (2);
- Put the plug in the wall socket;
- Press the minus sign on the remote control until you hear a beep;
- Place the top, including the water, back on Beam mini (2);
- Wait a moment until the water has drained from the water tank;
- Switch Beam mini (2) back on, the E1 message should no longer be visible.